Bently Nevada 42 Proximitor Seismic Monitor Module Op Maintenance: Complete Installation and Configuration Guide

As a senior automation engineer…

Specific Troubleshooting Guide for Proximitor/Seismic Monitor Module

This troubleshooting guide provides a systematic approach to identify and resolve common issues with the Bently Nevada 3500/42 Proximitor/Seismic Monitor Module.

Common Issues and Solutions

Issue: Module not powering on

Possible Causes:

Power supply failure
Improper installation in the rack
Faulty connections

Recommended Solutions:

Check power supply and connections
Ensure module is properly seated in the rack
Replace power supply if necessary

Issue: Incorrect readings from transducers

Possible Causes:

Misconfigured settings
Faulty transducer
Wiring issues

Recommended Solutions:

Verify configuration settings using the 3500 Rack Configuration Software
Test transducer functionality
Inspect and repair wiring connections

Issue: Alarm not triggering

Possible Causes:

Setpoints not configured correctly
Module malfunction
Transducer failure

Recommended Solutions:

Review and adjust alarm setpoints
Perform a self-test on the module
Replace faulty transducer if needed

Advanced Diagnostic Notes

Utilize the 3500 Rack Configuration Software to access advanced diagnostic features, including system event logs and alarm event messages, to further investigate issues.

For unresolved issues, consult the full manual or contact support.